Repeat Mode

0 (FREE): When started, the LETIMER counts down until it is stopped by software

1 (ONESHOT): The counter counts REP0 times. When REP0 reaches zero, the counter stops

2 (BUFFERED): The counter counts REP0 times. If REP1 has been written, it is loaded into REP0 when REP0 reaches zero, otherwise the counter stops

3 (DOUBLE): Both REP0 and REP1 are decremented when the LETIMER wraps around. The LETIMER counts until both REP0 and REP1 are zero

Underflow Output Action 0

0 (NONE): LETn_O0 is held at its idle value as defined by OPOL0

1 (TOGGLE): LETn_O0 is toggled on CNT underflow

2 (PULSE): LETn_O0 is held active for one LFACLKLETIMER0 clock cycle on CNT underflow. The output then returns to its idle value as defined by OPOL0

3 (PWM): LETn_O0 is set idle on CNT underflow, and active on compare match with COMP1

Underflow Output Action 1

0 (NONE): LETn_O1 is held at its idle value as defined by OPOL1

1 (TOGGLE): LETn_O1 is toggled on CNT underflow

2 (PULSE): LETn_O1 is held active for one LFACLKLETIMER0 clock cycle on CNT underflow. The output then returns to its idle value as defined by OPOL1

3 (PWM): LETn_O1 is set idle on CNT underflow, and active on compare match with COMP1

Output 0 Polarity

Output 1 Polarity

Buffered Top

Compare Value 0 is Top Value

Debug Mode Run Enable